Articles

Details

Created on Saturday, 28 February 2009 20:42

Last Updated on Sunday, 01 March 2009 14:05

Written by Emil Weiler

Windrider Bee Construction

Article by Emil Weiler

1) Splitting the spar in two is easy.	2) Cut spar slot with razor blade.
3) Widen slot with piece of 4-40, push down with stick. Thin CA in place.	4) Servos in place.
5) Radio gear and battery layout - this is on the bottom side of wing!!	6) Servo cover spacers.
7) Trailing edge tape.	8) Taped per Karl's "Bee Build".
9) Laminating film for top - 5 micron.	10)
11) Tape elevons on 45 degree angle down - tape goes on top of wing.	12) Pushrod exit.
13)	14)
15) Brush in 5200 for hinge.	16) Tape elevons at zero degrees overnight.
17)	18)
21) Finished top side	22) Finished bottom side